Connecting Example When Using The Contrast Synchronization Function/Shutter Synchronization Function - Panasonic PT-RZ21K Operating Instructions Manual

f For twisted‑pair‑cable transmitters of other manufacturers of which the operation has been verified with the projector, visit the Panasonic
website (https://panasonic.net/cns/projector/). Note that the verification for devices of other manufacturers has been made for the items set
by Panasonic Corporation, and not all the operations have been verified. For operation or performance problems caused by the devices of
other manufacturers, contact the respective manufacturers.
Connecting example when using the contrast synchronization function/shutter
synchronization function
In a case to construct a multi-display by linking projected images from multiple projectors, following functions can
be used by synchronizing multiple projectors using the <MULTI PROJECTOR SYNC IN> terminal and the <MULTI
PROJECTOR SYNC OUT> terminal.
f Contrast synchronization function
A linked screen with balanced contrast can be displayed by sharing the brightness level of the video signal
being input to each projector.
To use this function, set the [PROJECTOR SETUP] menu → [MULTI PROJECTOR SYNC] for each
synchronized projector as follows.
g Set [MULTI PROJECTOR SYNC] → [MODE] to anything other than [OFF].
Set [MODE] to [MASTER] only on one projector that is synchronized. Set [MODE] to [SLAVE] for all other
projectors.
g Set [MULTI PROJECTOR SYNC] → [CONTRAST SYNC] to [ON].
f Shutter synchronization function
This is a function to synchronize the shutter operation of the specified projector to other projectors, and the
effect using the shutter function including the fade in/fade out operation can be synchronized.
To use this function, set the [PROJECTOR SETUP] menu → [MULTI PROJECTOR SYNC] for each
synchronized projector as follows.
g Set [MULTI PROJECTOR SYNC] → [MODE] to anything other than [OFF].
Set [MODE] to [MASTER] only on one projector that becomes the synchronization source within the linked
projectors. Set [MODE] to [SLAVE] for all other projectors.
g Set [MULTI PROJECTOR SYNC] → [SHUTTER SYNC] to [ON].
r Connecting example
Connect all the projectors to be linked in a loop by daisy chain connection when using the contrast
synchronization function/shutter synchronization function. The number of linked projectors is limited to the
maximum of 64 projectors.
Connecting terminals of the synchronization source
Connecting terminals of the projector to
synchronize
56 - ENGLISH
Chapter 2 Getting Started — Connecting
Connecting terminals of the projector to
synchronize
Connecting terminals of the projector to
synchronize