Attaching/Removing The Projection Lens (Optional); Attaching The Projection Lens - Panasonic PT-RZ21K Operating Instructions Manual

Chapter 2 Getting Started — Attaching/removing the projection lens (optional)

Attaching/removing the projection lens (optional)

Move the projection lens to the home position before replacing or removing the projection lens. (x page 74)
Attention
f Replace the projection lens after turning off the power of the projector.
f Do not touch the electric contacts of the projection lens. Dust or dirt may cause poor contact.
f Do not touch the surface of the projection lens with your bare hands.
f Before attaching the projection lens, remove the lens cover attached to the projection lens.
f Panasonic takes no responsibility for any damage or malfunction of the product resulting from the use of projection lenses which are not
manufactured by Panasonic. Be sure to use the specified projection lenses.
Note
f The precautions for handling the lens are different for the Fixed‑focus Lens (Model No.: ET‑D75LE95, ET‑D75LE90). For details, refer to the
Operating Instructions of ET-D75LE95 or ET-D75LE90.

Attaching the projection lens

Attach the projection lens using the following procedure. Start from Step 3) when the lens hole cover is already
removed.
1) Loosen the screw fixing the lens hole cover. (Fig. 1)
f Use a Phillips screwdriver to turn the screw fixing the lens hole cover counterclockwise until it turns freely.
2) Remove the lens hole cover. (Fig. 2)
f While pressing the lens release button, turn the lens hole cover counterclockwise until the mark on the lens
hole cover (E) aligns with the mark on the projector (E on the left side of LOCK).
Screw
Lens hole cover
Fig. 1
Fig. 3
Lens release button
Mark (orange)
Fig. 2
Screw hole A
Lens fixing screw
Fig. 4
ENGLISH - 49