Blower Assembly; Vacuum Assembly - Weed Eater EBV 210 Instruction Manual

WARNING:
Stop the unit and
disconnect from the power source be-
fore opening the inlet cover or attempt-
ing to insert or remove the inlet restrictor,
blower tube, or vacuum tubes. The mo-
tor must be stopped and the impeller
blades no longer turning to avoid serious
injury from the rotating blades.
WARNING:
If received as-
sembled, ensure your unit is properly
assembled and all fasteners are secure.
S A standard screwdriver is required for
assembly.

BLOWER ASSEMBLY

NOTE: Assembly instructions for using
your unit as a vacuum follow this section.
Attaching the blower tube
If you have already assembled your unit
for use as a vacuum, refer to the section
HOW TO CONVERT UNIT FROM VACUUM
USE TO BLOWER USE.
To attach blower tube:
Align the grooves on the blower tube
S
with the grooves on the blower outlet.
Push the blower tube onto the blower
S
outlet until it snaps into place (tube is
secured by red tube release button).
To remove the blower tube, press the
S
tube release button while pulling on
tube.
Tube Release Button
Blower Tube
Blower outlet

VACUUM ASSEMBLY

NOTE: Assembly instructions for using
your unit as a blower are explained in the
previous section.
If you have already assembled your unit
for use as a blower, remove the blower
tube.
Remove the inlet restrictor
An inlet restrictor is used when using your
unit as a blower. This restrictor is not used
during vacuum use and must be removed
during assembly for vacuum use.
NOTE: Be sure to keep the inlet re-
strictor for using your unit as a blower.
Ensure unit is stopped and extension
S
cord is unplugged.
ASSEMBLY
Open the inlet cover by inserting the
S
tip of a screwdriver into the latch area
on the blower unit. Gently tilt handle of
screwdriver toward the front of the unit
to release the latch while pulling up on
the vacuum inlet cover with your other
hand.
Bottom view
of unit
Vacuum Inlet Cover (closed)
Impeller
Vacuum Inlet Cover (opened)
Turn the inlet restrictor counterclock-
S
wise and remove it from the unit. Do not
close the inlet door. You will next attach
the vacuum tubes.
Inlet
Restrictor
Attaching the vacuum tubes
There are 2 vacuum tubes, an upper
tube and a lower tube. The upper tube
has a vacuum assist handle attached to
one end and is cut straight on both ends.
The upper tube attaches to the blower
unit. The lower tube has an angled end
that you point toward the ground during
vacuum use. The lower tube attaches to
the upper tube.
Ensure unit is stopped and extension
S
cord is unplugged.
While holding inlet cover open, place
S
the hooks of the vacuum assist handle
on the retaining posts of the unit.
Hook
5
Latch Area
Latch Area
Vacuum
Inlet Cover
Upper Vacuum Tube
Vacuum Assist Handle