Configuring Igmp Filtering And Throttling - Cisco Catalyst 2975 Software Configuration Manual

Configuring IGMP Filtering and Throttling

Configuring IGMP Filtering and Throttling
In some environments, for example, metropolitan or multiple-dwelling unit (MDU) installations, you
might want to control the set of multicast groups to which a user on a switch port can belong. You can
control the distribution of multicast services, such as IP/TV, based on some type of subscription or
service plan. You might also want to limit the number of multicast groups to which a user on a switch
port can belong.
With the IGMP filtering feature, you can filter multicast joins on a per-port basis by configuring IP
multicast profiles and associating them with individual switch ports. An IGMP profile can contain one
or more multicast groups and specifies whether access to the group is permitted or denied. If an IGMP
profile denying access to a multicast group is applied to a switch port, the IGMP join report requesting
the stream of IP multicast traffic is dropped, and the port is not allowed to receive IP multicast traffic
from that group. If the filtering action permits access to the multicast group, the IGMP report from the
port is forwarded for normal processing. You can also set the maximum number of IGMP groups that a
Layer 2 interface can join.
IGMP filtering controls only group-specific query and membership reports, including join and leave
reports. It does not control general IGMP queries. IGMP filtering has no relationship with the function
that directs the forwarding of IP multicast traffic. The filtering feature operates in the same manner
whether CGMP or MVR is used to forward the multicast traffic.
IGMP filtering is applicable only to the dynamic learning of IP multicast group addresses, not static
configuration.
With the IGMP throttling feature, you can set the maximum number of IGMP groups that a Layer 2
interface can join. If the maximum number of IGMP groups is set, the IGMP snooping forwarding table
contains the maximum number of entries, and the interface receives an IGMP join report, you can
configure an interface to drop the IGMP report or to replace the randomly selected multicast entry with
the received IGMP report.
IGMPv3 join and leave messages are not supported on switches running IGMP filtering.
Note
These sections contain this configuration information:
•
•
•
•
•
Catalyst 2975 Switch Software Configuration Guide
22-24
Default IGMP Filtering and Throttling Configuration, page 22-25
Configuring IGMP Profiles, page 22-25
Applying IGMP Profiles, page 22-26
Setting the Maximum Number of IGMP Groups, page 22-27
Configuring the IGMP Throttling Action, page 22-28
Chapter 22
(optional)
(optional)
(optional)
(optional)
Configuring IGMP Snooping and MVR
OL-19720-02