Lan Port Ip; Gateway Ip; Acls; Context-Based Access Control - Cisco Catalyst 2975 Software Configuration Manual

Ios release 12.2(55)se
Hide thumbs Also See for Catalyst 2975:
Table of Contents

Advertisement

Understanding Web-Based Authentication

LAN Port IP

You can configure LAN port IP (LPIP) and Layer 2 web-based authentication on the same port. The host
is authenticated by using web-based authentication first, followed by LPIP posture validation. The LPIP
host policy overrides the web-based authentication host policy.
If the web-based authentication idle timer expires, the NAC policy is removed. The host is authenticated,
and posture is validated again.

Gateway IP

You cannot configure Gateway IP (GWIP) on a Layer 3 VLAN interface if web-based authentication is
configured on any of the switch ports in the VLAN.
You can configure web-based authentication on the same Layer 3 interface as Gateway IP. The host
policies for both features are applied in software. The GWIP policy overrides the web-based
authentication host policy.

ACLs

If you configure a VLAN ACL or a Cisco IOS ACL on an interface, the ACL is applied to the host traffic
only after the web-based authentication host policy is applied.
For Layer 2 web-based authentication, you must configure a port ACL (PACL) as the default access
policy for ingress traffic from hosts connected to the port. After authentication, the web-based
authentication host policy overrides the PACL.
You cannot configure a MAC ACL and web-based authentication on the same interface.
You cannot configure web-based authentication on a port whose access VLAN is configured for VACL
capture.

Context-Based Access Control

Web-based authentication cannot be configured on a Layer 2 port if context-based access control
(CBAC) is configured on the Layer 3 VLAN interface of the port VLAN.
802.1x Authentication
You cannot configure web-based authentication on the same port as 802.1x authentication except as a
fallback authentication method.

EtherChannel

You can configure web-based authentication on a Layer 2 EtherChannel interface. The web-based
authentication configuration applies to all member channels.
Catalyst 2975 Switch Software Configuration Guide
11-8
Chapter 11

Configuring Web-Based Authentication

OL-19720-02

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents