Rheem 70103 Service Instructions Manual page 16

5. Press and release the (▲) button until the desired minutes appear flashing on the
screen.
6. Press and release the (
'SUN X:XX – X:XX Set OFF hour' will be displayed on the screen.
7. Press and release the (▲) button until the desired hour appears flashing on the
screen.
8. Press and release the (
'SUN X:XX – X:XX
9. Press and release the (▲) button until the desired minutes appear flashing on the
screen.
10. Press and release the (
'MON 7:00 – 17:30
11. Continue steps 3 – 8 for Monday through to Saturday. When step 8 is completed for
Saturday the display will automatically revert to the main menu and the program will
be saved.
Note: To program the unit to be in 'OFF' mode for an entire day, set the 'ON' and 'OFF'
times to be the same i.e. 'ON = 0:00 OFF = 0:00'
Programming 'Sleep Delay Time'
1. Press and release the (P) button until 'Sleep Delay Time' is displayed flashing on
the screen.
2. Press and release the (
be displayed on the screen with 'OFF' flashing.
3. Press and release the (▲) button until the desired time setting appears flashing on
the screen. Each consecutive push and release of the (▲) button increases the time
setting in one hour increments up to a maximum of 6 hours. If the (▲) button is
pressed and released after '6' is reached 'OFF' will be displayed and if accepted,
the sleep delay timer will be turned off.
4. When the desired setting is reached press and release the (
selection. The display will revert to the main menu and the setting will be saved.
Note: The sleep function puts the unit in a standby mode after a user defined period (1 – 6
hours). The unit will enter 'Sleep' mode if it has not been used for the programmed
'Sleep Delay Time' period. During 'Sleep mode' the unit will change the Treq boiling
water temperature to 0ºC instead of the normal Treq (approximately 97ºC). To exit
sleep mode, press any Timer button to reactivate the unit. The unit will then operate
normally.
Selecting 'Filter Life' Functions
The Filter Life function has three modes to select from, 'Remaining Life', 'Filter Reset' and
'Set Filter Life'. These modes are accessed as follows:
Accessing 'Remaining Life'
1. Press and release the (P) button until 'Filter Life' is displayed flashing on the
screen. Note: if 'Remaining Life – COUNT IS OFF' is displayed on the screen
proceed directly to step 3 otherwise proceed to step 2.
TM063 701, 702 & 703 Series Boiling Water Unit Service Instructions
Revision D: Feb 2017
This document is stored and maintained electronically by
✓ ) button to confirm selection.
) button to confirm selection.
✓
Set OFF Minute' will be displayed on the screen.
) button to confirm selection.
✓
Set ON hour' will be displayed on the screen.
) button to confirm selection. 'Sleep Delay Time OFF' will
✓
Service. All printed copies not bearing this statement in RED are deemed "uncontrolled"
✓ ) button to confirm
16