Adjusting Depth Of Cut; Operation; Connecting To Power Source - Porter-Cable 7536 Instruction Manual

ADJUSTING DEPTH OF CUT

1.
TOOL FROM POWER SOURCE.
2. Loosen clamp screw (A) Fig. 5.
3. While holding base (E), turn
motor unit
COUNTERCLOCKWISE until the tip
of the bit is above bottom surface of
base.
4. Set router on flat wood surface.
5. Turn motor unit (F) Fig. 5
CLOCKWISE until bit touches the
wood surface.
6. Tighten clamp screw (A) Fig. 5.
7. Rotate depth adjusting ring (B)
Fig. 5 until the zero-line (C) is
opposite the index line (D) on the
housing.
8. Loosen clamp screw (A) Fig. 5.
9. Tip the router so bit is clear of
the wood surface. Turn motor unit
(F) Fig. 5, CLOCKWISE until the
index line (D) on the motor housing
reaches the desired depth indicated
on the ring.
10. Tighten clamp screw (A) Fig. 5
firmly.
NOTE: Setting the index line to
edge of the bit is exposed
CONNECTING TO POWER
SOURCE
Before connecting
tool to power source, CHECK TO
SEE THAT THE SWITCH IS IN
THE "OFF" POSITION. Also,
check the power circuit to see that
it is the same as that shown on
specification plate of the tool.
D I S C O N N E C T
(F) Fig.
1 " below the base.
/
4

OPERATION

5
A
E
1 " on the ring means the cutting
/
4
A
8
C
Fig. 4
F
B
D
C
Fig. 5
Fig. 6