Table of Contents
Advertisement
7.
To remove the bit, reverse the foregoing procedure. If bit does not
remove easily, tap the collet nut with wrench to release.
ASSEMBLING THE MOTOR IN THE ROUTER BASE
EQUIPPED WITH TWO HANDLES
1.
2.
Loosen the clamp screw (A) Fig. 1 to allow the power unit to be set in
the base unit.
3.
Insert motor unit into base aligning lower pin (B) with groove in base.
4.
Rotate motor unit CLOCKWISE into base until upper guide pins are
rigidly set in the groove of the base.
5.
Tighten clamp screw firmly.
ASSEMBLING THE MOTOR IN THE ROUTER BASE
EQUIPPED WITH SWITCH IN-HANDLE
1.
FROM POWER SOURCE.
2.
Loosen clamp screw (A) Fig. 3 to allow the power unit to be set in the
base unit.
3.
With the motor switch (C) positioned as shown in Fig. 3, insert the motor
unit into the base aligning lower pin (B) with groove in base.
4.
Rotate the motor unit CLOCKWISE into the base two revolutions.
5.
Connect the motor unit cord to the outlet in handle as shown in Fig. 4.
6.
Tighten clamp screw firmly.
Fig. 2
B
A
AVOID POSSIBLE DAMAGE TO COLLET.
NEVER TIGHTEN COLLET WITHOUT BIT.
DISCONNECT MOTOR FROM POWER SOURCE.
DISCONNECT BOTH POWER CORDS (base and motor)
Fig. 1
B
A
7
C
Fig. 3
Hide quick links:
Advertisement
Table of Contents
