Windows Security pop-up warning appears, click on Install this driver software
3.
anyway.
NOTE:
Make sure not close the Command Line interface until the driver installation is complete.
Wait until the driver is installed and the Install Complete! status appears on Command
4.
Line interface as follows.
Double-click to open the "gsensorconfig.txt" in a text editor and configure the GSensor
5.
Calibration specification as follows: (The values should be higher than 0.4).
•
GSENSORMISAGAINX=<0.5>
•
GSENSORMISAGAINY=<0.5>
•
GSENSORMISAGAINZ=<0.4>
Enable the USB debug mode on PAD.
6.
Connect the PAD to the PC via MicroUSB cable.
7.
Diagnostic Utilities
Figure 2-39. Warning Message
Figure 2-40. Driver Installation Is Complete
2-22