Commands In This Chapter; Boot Auto-Copy-Sw - Dell PowerConnect 7000 Series Reference Manual

4 Support for the Auto-Install process from a TFTP server operationally
enabling the DHCP client on designated management interfaces during
the Auto-Install process. The end user configuration remains unchanged.
Management interfaces include the service port or routing interfaces in a
saved config.

Commands in this Chapter

This chapter explains the following commands:

boot auto-copy-sw

boot auto-copy-sw allow-downgrade
boot host autoreboot
boot host autosave
boot host dhcp
boot host retrycount
boot auto-copy-sw
boot auto-copy-sw
Use the boot auto-copy-sw command in Privileged EXEC mode to enable or
disable Stack Firmware Synchronization.
Use the no form of the command to disable Stack Firmware Synchronization.
Syntax
boot auto-copy-sw
no boot auto-copy-sw
Parameter Description
This command does not require a parameter description.
Default Configuration
Stack firmware synchronization is disabled by default.
1296
Auto-Install Commands
boot auto-copy-sw allow-downgrade
boot host autoreboot
boot host autosave
boot host dhcp
boot host retrycount
show auto-copy-sw
show boot