Power Inline Detection - Dell PowerConnect 7000 Series Reference Manual

console(config-if-1/0/1)# power inline auto

power inline detection

Use the power inline detection command in Interface Configuration mode
to configure the detection type that tells which types of PD's will be detected
and powered by the switch. Use the no form of this command to set the
detection type to the default.
Syntax Description
power inline detection { dot3af | dot3af+legacy | legacy-only }
no power inline detection
Parameter Description
Parameter
dot3af
dot3af+legacy
legacy-only
Default Value
Default value is dot3af.
Command Mode
Interface Configuration
User Guidelines
This command has no user guidelines.
power inline high-power
Use this command to configure the port high power mode. Use the no form
of this command to disable high power mode. In high power mode, the
switch (PSE) negotiates the power budget with the powered device (PD) via
LLDP .
Description
IEEE 802.3af 4-point detection only.
IEEE 802.3af 4-point detection followed by Legacy.
Legacy capacitive detection only.
Power Over Ethernet Commands
1447