Cell - Sennheiser GuidePort System Manual

2.3.2 Hardware Interfaces
a) Front panel
TX I
Headphone Outputs
Allow you to monitor the audio signals transmitted to the receivers.
b) Rear panel
TX II
AAU OUT
0
USB IN
I
USB IN:
Input socket for the USB cable from the Base Station PC.
ANALOG IN SYM.:
Inputs for connecting your audio sources to the transmitter. There are four balanced
inputs, you can either connect 4 mono sources, 2 mono sources and 1 stereo source or
2 stereo sources. For a stereo audio source, you will need two sockets (left and right
channel), please use inputs 1 & 2 and/or 3 & 4. Connect the left audio channel to
socket No. 1 or 3, the right audio channel to No. 2 or 4, respectively.
The following table shows how to connect your audio sources to the GuidePort Cell
Transmitter:
Number and kind of audio
sources
4 mono (m)
2 mono (m), 1 stereo (s)
2 stereo (s)
AAU OUT
Output for connection of an Active Antenna Unit. Use a shielded, 8-wire twisted pair
cable (4 individually twisted pairs) for connection. This cable supplies the Active
Antenna Unit with DC and the digital data stream to be transmitted.
GuidePort: System Manual
SET
TIP: +
ANALOG IN SYM.
RING: -
1 2 3 4
Input No. 1 Input No. 2
m
m
s, left
27. November 2000
GuidePort SR 3000-2
TX II
TX I
AAU OUT
USB IN
Input No. 3
m m
m s, left
s, right s, left
SET
TIP: +
ANALOG IN SYM.
RING: -
1 2 3 4
Input No. 4
m
s, right
s, right
Seite 6