Lincoln Electric Power Wave S500 K2904-1 Operator's Manual page 17

POWER WAVE ® S500
SMAW (STICK) WELDING
Similar to TIG welding a user interface is required for adjusting the
Stick welding settings. A Power Feed wire feeder can be used as
the user interface, or a K3001-2 (user interface control panel) can
be installed into the power source (Figure A.3). The connection
diagram shown is based on the S-Series user interface (K3001-2).
In this diagram the remote control box is optional.
WORK CLAMP
FIGURE A.3
STICK WITH S-SERIES USER INTERFACE
USER INTERFACE
CONTROL PANEL
K3001-2
TO NEGATIVE (-) STUD
TO POSITIVE (+) STUD
WORK PIECE
A-7
TO REMOTE CONTROL
RECEPTACLE
ELECTRODE HOLDER KIT
K2394-1 KIT
(INICLUDES GROUND CLAMP)
INSTALLATION
REMOTE CONTROL BOX
K857