Table of Contents
Advertisement
eAN3810A
Hardware Installation Guide
Figure 1-31 Correct direction for crimping an OT terminal
Step 3 Label the installed cable.
----End
1.9.4 Installing a RF Jumper
This section describes the procedure for installing an RF jumper.
Procedure
Step 1 Remove the dustproof cap from the ANT port to be used on the eAN3810A.
Step 2 Connect the type N male connector at one end of the eAN3810A RF jumper to the ANT port
at the bottom of the eAN3810A in sequence, and use a torque wrench to tighten the connector
to 1 N·m (8.85 lbf·in.), as shown in Figure1.
Issue 01 (2017-04-30)
Follow the same procedure when installing a Dock PGND cable.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 eAN3810A Hardware Installation Guide
34
Advertisement
Table of Contents
