Connecting The Power Adapter And Power Cord; Connecting The Ethernet Port; Connecting The Pots Port - ADTRAN 6304W Configuration Manual

Installing the ONU
8

Connecting the Power Adapter and Power Cord

Follow these steps to connect the power adapter to the ONU.
1 Insert one end of the power cord attached with the power adapter into the
POWER connector.
Press the ON/OFF button to ensure that the power status is ON.
2
3 Check whether the Power LED is on. If it is on, the power supply is normal.
Otherwise, check whether the power cord and the power adapter are correctly
connected.
Follow these steps to connect the UPS to the ONU.
1 Insert one end of the power cord attached with the UPS device into the UPS slot.
Press the ON/OFF button to ensure that the power status is ON.
2
Check whether the Power LED is on. If it is on, the power supply is normal. Oth-
3
erwise, check whether the power cord and the UPS device are correctly con-
nected.

Connecting the Ethernet Port

Follow these steps to connect to the Ethernet port.
1 Insert one end of a network cable with an RJ-45 connector into the Ethernet
port.
Insert the other end of the cable to a PC or Switch.
2
3 Check whether the Link LED is on. If it is on, the link is connected and
operational. Otherwise, check whether the cable is plugged in properly.

Connecting the POTS Port

Follow these steps to connect to the POTS port.
Insert one end of a cable with an RJ-11 connector into the POTS port.
1
2 Insert the other end of the cable to a telephone.
6304W Installation Guide