Operating Position - Whirlpool GS440LELB0 Installation Instructions Manual

Operating position
front leveling leg
/
rear leveling leg "_<:__
mRemove cardboard shipping base from
under range. Remove storage drawer. Use a
3/8" drive ratchet to Uower rear UeveUing Uegs
one-half turn. Use channeUUockpUiersto Uower
front UeveUing Uegsone-haUfturn.
Before moving range across floor, check that
range is still on cardboard shipping base to
protect floor covering.
B Making sure the
anti-tip bracket is
,
Look for the
ant_-tlp_,_ _',,_ R _ _ \\
anti-tip bracket urac,et \____._
securely attached to _
range
foot
floor.
• Slide range back so rear range foot is under
Replace storage drawer.
7_[f installing the range in a mobile
home, you MUST secure the range to the floor.
Any method of securing the range is adequate as
long as it conforms to the "Manufactured Home
Construction and Safety Standard," Page 2.
mPlace rack in oven. Place level on rack,
first side to side; then front to back.
If range is not level, pull range forward until
rear leveling leg is removed from the anti-tip
bracket. Use 3/8" drive ratchet and channel
lock pliers to adjust leveling legs up or down
until range is level. Push range back into
position. Check that rear leveling leg is
engaged in anti-tip bracket.
Note: Oven must be teve_ for satisfactory
baking conditions.
Gas and electrical connections
AH connections must be wrench=tightened.
Typical rigid pipe connection
)
mUse a brush and liquid detergent
to test all gas connections. Bubbles around
connections will indicate a leak. If a leak
appears, shut off gas valve controls and
tighten connections. Then check connections
again. Clean all detergent from range.
..... union
pressure
regulator :_ black iron
pipe
manuaJ
gas
shutoff
valve
\
90°e_bew
union nipple 1/2" to 3/4"
gas pipe
Typical fle×ible connection
pressure use pipe-joint
regulator compound
J'nanua_
Use 15/16" combination wrench and
channel lock pliers to attach the flexible
connector to the adapters. Check that connector
is not kinked.
uCenter the burner cap on burner
base. Burner cap should be level when
properly positioned. Place burner grates
over burner.
Plug power supply cord into
grounded electrical outlet.
adapt!// 1/2" to 3/4"
/ gas pipe
use pipe=joint
compound
A 1/2" mate pipe thread is needed for connection to
pressure regulator female pipe threads,
9 _Apply pipeoioint compound made for
use with L. P. gasto the smaller thread ends of
the flexible connector adapters. Attach one
adapter to the pressure regulator elbow and
the other adapter to the gas shutoff valve.
Tighten both adapters.
_anual shutoff
valve _
"open" position __..,_
mCheck that pressure regulator shutoff
valve is in the "on" position. Open the manual
shutoff valve in the gas supply line.
Page 5