Epson AL-M320DN User Manual page 73

AL-M320DN/AL-M310DN/AL-M220DN User's Guide
To clear this warning message, select Clear Warning
from the control panel's Reset Menu.
Clear Paper Jam wwww
The location where the paper jam occurred is displayed
at WWWWW. WWWWW indicates the location of the error.
If a paper jam occurs at two or more locations
simultaneously, the corresponding multiple locations
are displayed.
For details about clearing paper jams, see
Jammed Paper" on page 84.
Close Cover wwww
The specified cover (wwww) does not close securely.
Open the cover once, and then close.
Collate Disabled
Printing by specifying the number of copies is no longer
possible due to a lack of memory (RAM). If this warning
message appears, print only one copy at a time.
To clear this warning message, select Clear Warning
from the control panel's Reset Menu.
Correct Time using Time Setting
The time and date are at their default values.
Set the time and date.
To clear this warning message, select Clear Warning
from the control panel's Reset Menu.
Duplex Memory Overflow
There is not enough memory for duplex printing. The
printer prints only on the front and ejects the paper. To
clear this error, follow the instructions below.
If Off is selected as the Auto Cont setting on the control
panel's Setup Menu, press the OK button to print on
the back of the next sheet, or cancel the print job. To
cancel the print job, see "Cancelling a Print Job" on
page 62.
If On is selected as the Auto Cont setting on the control
panel's Setup Menu, printing continues automatically
after a certain period of time.
F/W Update
Troubleshooting
Firmware is being updated. Do not turn off the power
until the update is complete.
F/W Update: Error
The firmware update failed. Turn the power off and on,
and then try to update again.
Feed Roller C1 Needed Soon, Feed Roller C2 Needed
Soon (AL-M320DN only), Feed Roller C3
(AL-M320DN only)
"Clearing
This warning message indicates that the indicated feed
roller is near the end of its service life. You can continue
printing until a message to replace the indicated feed
roller appears.
Filling Toner mm min
Wait mm minutes for the toner to fill.
Form Feed
The printer is ejecting paper due to a user request. This
message appears when pressing the Pause/Release
button once, then holding down the OK button for
more than 2 seconds because the printer has not
received a form feed command.
Fuser Needed Soon (AL-M320DN only)
This message indicates that the fuser unit is near the end
of its service life. You can continue to print until the
Replace Fuser message appears.
Image Optimum
There is insufficient memory to print the page at the
specified print quality. The printer automatically lowers
the print quality so that it can continue printing. If the
quality of the printout is not acceptable, try simplifying
the page by limiting the number of graphics or reducing
the number and size of fonts.
To clear this warning message, select Clear Warning
from the control panel's Reset Menu.
Install Toner Cartridge
The toner cartridge is not installed in the printer.
Install the toner cartridge. See the instructions that
come with the toner cartridge.
Invalid Data
73