ROTARY SWITCH SETTING
Indoor unit address setting (SW3)
z
This switch can be used when group control system. Set the indoor unit address in the 1,2,-,15
order.
SW 3
0
1-15
JUMPER WIRE SETTING
JM1, 2 setting forbidden
z
Fan delay setting (JM3)
z
When the indoor unit is stopped while operating in conjunction with auxiliary heater, the indoor unit
fan operation will continue for one minute.
Connect
Disconnect
( . . .Factory setting)
SW state
single
Indoor unit address
( . . .Factory setting)
JM state
Invalid
Valid
- (01 - 27) -