Compliance information
User Manual
4
H57555 Revision A
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
For product available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
This device is restricted for indoor use.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator & your body.
IMPORTANT NOTE:
This module is intended for OEM integrator only and limited to host with brand:
HUGHES and model: HT2000W. The OEM integrator is still responsible for the FCC
compliance requirement of the end product, which integrates this module.
USERS MANUAL OF THE END PRODUCT:
In the user's manual of the end product, the end user has to be informed to keep at
least 20 cm separation with the antenna while this end product is installed and
operated. The end user has to be informed that the FCC radio‐frequency exposure
guidelines for an uncontrolled environment can be satisfied.
The end user has to also be informed that any changes or modifications not
expressly approved by the manufacturer could void the user's authority to operate
this equipment.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following: "Contains
TX FCC ID: RAXHT2000W".
The FCC part 15.19 statement below has to also be available on the label: This
device complies with Part 15 of FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device
must accept any interference received, including interference that may cause
undesired operation.