Configuring Stereosurround Settings - Polycom VSX Series Administrator's Manual

Configuring StereoSurround Settings

To send or receive stereo audio, make sure your VSX system equipment is set
up as described in Connecting Microphones or a SoundStation VTX 1000
page 2-19 and Connecting Speakers
to use Polycom StereoSurround, test the system configuration, and place a test
call.
If you are in a call with a far site that is sending audio in stereo mode, you can
receive in stereo. In multipoint calls where some sites can send and receive
stereo and some sites cannot, any site that is set up to send or receive stereo
will be able to do so.
Points to note about StereoSurround:
• Camera tracking is disabled when you enable StereoSurround.
• If StereoSurround is enabled on a VSX 6000 or VSX 7000, the system cannot
record audio from a call.
For information about other features that are not compatible with StereoSurround,
refer to the troubleshooting information on page 7-27.
To configure systems to send and receive Polycom StereoSurround:
Go to this screen:
Audio
System > Admin Settings > Audio
Audio Levels
System > Admin Settings > Audio >
Audio Settings > Next > Next
VSX 7000, VSX 7000s
Customizing the VSX System
on page 2-26. Then configure the system
Configure these settings:
Set Enable Polycom StereoSurround.
Set Subwoofer Speaker to Off.
on
4 - 25