Table of Contents
Advertisement
CHAPTER 4: ACTUAL VALUES
A4 Target messages
350 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
Target messages are automatically displayed for any active condition on the relay such as
pickups, trips, alarms, or asserted input. The target messages shown in the table below are
displayed as necessary.
The relay displays the most recent event first, and after 5 seconds starts rolling up the
other target messages, until the Reset command is initiated. If the Reset command is not
performed, but any of the other faceplate pushbuttons is pressed, the display will not
show the target messages, unless the user navigates to
, where they can be reviewed.
MESSAGES
The target messages can be reviewed by pressing Up and Down message pushbuttons
from the relay keypad.
For a complete list of Active Targets, see Format Code FC134A in the 3 Series
Communications Guide. Note that the format codes differ for each relay model.
•
The PKP messages will appear on the relay display as long as their respective flags are
active. The messages will disappear from the display, when either the protection
element drops out before operation, such as when the condition clears before
reaching operation, or when the protection element operates.
•
The OP and BKR Status messages will appear on the relay display, when the
respective element operates, with the element function set to "TRIP", or "LATCHED
ALARM". The message will stay on the display after the condition clears, and will
disappear upon Reset command. If the element function is selected to "ALARM", or
"CONTROL", the message will disappear from the display, when the condition causing
operation clears.
•
The Breaker Open and Breaker Close messages will appear on the display and stay for
5 seconds only, unless the reset command is initiated, or the element changes its
state. For example, if the breaker is detected "Open", the message "Breaker Open OK"
will appear on the display and will stay for 5 seconds, unless the breaker status
changes to "Close". If the breaker status changes to "Close" within 5 seconds after the
breaker has been detected open, the message "Breaker Open OK" will disappear, and
the message "Breaker Close OK" will appear and stay for 5 seconds.
•
The Contact Input ON/OFF, Virtual Input ON/OFF, and Remote Input ON/OFF messages
will not appear as target messages upon change of state. The state change, however,
will be logged in the Event recorder.
Autoreclose target messages
AR Ready
AR IN-PROGRESS
AR LOCKOUT
Examples of how the messages appear on the display:
Example 1:
Phase IOC1 Settings:
•
PH IOC1 FUNCTION = Trip
•
PH IOC1 PICKUP = 1.00 x CT
•
PH IOC1 DELAY = 0.20 s
Appears on the display when the
AR is Ready, i.e. breaker closed,
AR function enabled, and no AR
initiation.
Appears on the display when the
AR is in progress
Appears on the display when the
AR is in lockout mode
A4 TARGET MESSAGES
ACTUAL VALUES > A4 TARGET
The message appears on the
display for 5 seconds, when the
AR is detected Ready.
Self-Reset message
Latched message. The message
disappears upon Reset command
4–17
Advertisement
Table of Contents
