Safety And Compliance; Part 15 Rules; Class B Digital Device Or Peripheral - Polycom IP 600 SIP User Manual

No Response from Feature Key Presses
Verify telephone is in active state:
• Make a call to the telephone to check
Directories
for inbound call display and ring-
Services
ing as normal. If successful, try to
press feature keys within the call to
Conference
access Directory or Buddy Status for
Transfer
example.
Redial
Hold
Display shows "Network Link is Down"
Verify LAN cable is properly connected:
• Check termination at the switch or
Directories
hub (furthest end of the cable from the
Services
telephone).
Conference
• Check that the switch or hub is opera-
tional (flashing link/status lights) or
Transfer
contact your System Administrator.
Redial
Hold

Safety and Compliance

Part 15 Rules

This device complies with Part 15 of the
FCC Rules. Operation is subject to the fol-
lowing two conditions:
1. This device may not cause harmful
interference, and

Class B Digital Device or Peripheral

Note: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harm-
ful interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interfer-
ence to radio communications. However,
there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
• Press
1 ABC 2 3 DEF
1 2 3
ABC DEF
4 5 6
GHI JKL MNO
4 5 6
• Reboot the telephone to attempt
GHI JKL MNO
7 8 9
PQRS TUV WXYZ
7 8 9
PQRS TUV WXYZ
0
OPER
* #
0
OPER
1 2 3
ABC DEF
1 2 3
ABC DEF
4 5 6
GHI JKL MNO
4 5 6
GHI JKL MNO
7 8 9
PQRS TUV WXYZ
7 8 9
PQRS TUV WXYZ
0
OPER
*
#
0
OPER
2. This device must accept any
be determined by turning the equipment
off and on, the user is encouraged to try
to correct the interference by one or more
of the following measures:
19
Sel
Del
followed by System
Menu
Status and Server Status to confirm
Messages
line is actively registered to the
server.
Do Not Disturb
re-registration to the server.
Hold
Sel
Del
• Press followed by System
Menu
Status and Network Status. Scroll
Messages
down to verify LAN port is Active.
Do Not Disturb
• Reboot the telephone to attempt
reconnection to the network.
Hold
interferences received, including in-
terference that may cause undesired
operation.
1. Reorient or relocate the receiving
antenna.
2. Increase the separation between the
equipment and receiver.
3. Connect the equipment into an out-
let on a circuit different from that
to which the receiver is connected.
4. Consult the dealer or an experience
radio/TV technician for help.