External Data Backup Through The Ethernet Interface - Siemens SINUMERIK 808D ADVANCED Diagnostic Manual

Data backup
6.3 External data backup
See also
Siemens Website (http://www.ad.siemens.com.cn/download/)
6.3.5

External data backup through the Ethernet interface

With the tool Access MyMachine P2P (AMM) installed on your PC/PG, you can enable the
Ethernet connection between a controller and a PC/PG (refer to Section "Configuring the
Ethernet connection (Page 46)"). This tool is available in the SINUMERIK 808D ADVANCED
Toolbox and is supported by Windows XP/Vista/Win 7. For more information about the AMM
tool, refer to the SINUMERIK 808D ADVANCED Commissioning Manual.
There are two methods available for backing up the system data files through the Ethernet
interface.
Method 1
Prerequisites:
•
The AMM tool has been installed on your PC.
•
An Ethernet connection (either direct connection or network connection) has been
established between the control system and the PC.
After an Ethernet connection is established, you can have a remote access to the NC file
system with the AMM tool.
460
NC side:
SinuComPCIN:
15. Wait until SinuComPCIN has finished data transfer, and click this
button.
Diagnostics Manual, 08/2013, 6FC5398-6DP10-0BA1
Diagnostics Manual