HP 10500 Series Configuration Manual page 186

# Specify an IPv4 address for interface Tunnel 2.
[SwitchB-Tunnel2] ip address 10.1.2.2 255.255.255.0
# Configure the tunnel encapsulation mode as IPv4 over IPv4.
[SwitchB-Tunnel2] tunnel-protocol ipv4-ipv4
# Specify the IP address of VLAN-interface 101 as the source address for interface Tunnel 2.
[SwitchB-Tunnel2] source 3.1.1.1
# Specify the IP address of VLAN-interface 101 of Switch A as the destination address for interface
Tunnel 2.
[SwitchB-Tunnel2] destination 2.1.1.1
# Apply service loopback group 1 on the tunnel.
[SwitchB-Tunnel2] service-loopback-group 1
[SwitchB-Tunnel2] quit
# Configure a static route destined for the IP network Group 1 through interface Tunnel 2.
[SwitchB] ip route-static 10.1.1.0 255.255.255.0 tunnel 2
Verifying the configuration
# Display the status of the tunnel interfaces on Switch A and Switch B:
[SwitchA] display interface tunnel 1
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 1480
Internet Address is 10.1.2.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 2.1.1.1, destination 3.1.1.1
Tunnel bandwidth 64 (kbps)
Tunnel protocol/transport IP/IP
Last clearing of counters:
Last 300 seconds input:
Last 300 seconds output:
4 packets input,
0 input error
12 packets output,
0 output error
[SwitchB] display interface tunnel 2
Tunnel2 current state: UP
Line protocol current state: UP
Description: Tunnel2 Interface
The Maximum Transmit Unit is 1480
Internet Address is 10.1.2.2/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 3.1.1.1, destination 2.1.1.1
Tunnel bandwidth 64 (kbps)
Tunnel protocol/transport IP/IP
Last clearing of counters:
Last 300 seconds input:
Never
0 bytes/sec, 0 packets/sec
2 bytes/sec, 0 packets/sec
256 bytes
768 bytes
Never
0 bytes/sec, 0 packets/sec
177