External Equipment; Others - Panasonic SC-UX100 Owner's Manual

SC-UX100 PP TQBJ0973 En.fm Page 12 Saturday, August 13, 2016 5:06 PM

External equipment

You can connect a VCR, DVD player etc., and listen to
the audio through this system.
Preparation
• Disconnect the AC power supply cord.
• Turn off all equipment and read the appropriate
operating instructions.
Rear panel of
this main unit
Audio cable
(not supplied)
1
Connect the external equipment.
2
Press [RADIO/AUX] to select "AUX".
3
Play the external equipment.
To adjust the input level
1
Press [PLAY MENU] to select "INPUT LEVEL".
2
Press [R, T] to select "NORMAL" or "HIGH" and
then press [OK].
Note:
• Select "NORMAL" if the sound is distorted during "HIGH"
input level.
•
Components and cables are sold separately.
• If you want to connect equipment other than those
described, refer to the audio dealer.
•
Sound distortion can occur when you use an adapter.
12
Confidential
Until: 9 Jan 2017
DVD player (not supplied)
digital printing

Others

Illumination
You can turn on or turn off the illumination on the system.
1
Press [SETUP] to select "ILLUMINATION".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Auto off
This system automatically turns off when you do not use
it for approximately 20 minutes.
1
Press [SETUP] to select "AUTO OFF".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
This function does not work when you are in radio source or
when a Bluetooth device is connected.
®
Bluetooth standby
®
This function automatically turns on the system when you
connection from a paired device.
establish a Bluetooth ®
1
Press [SETUP] to select "BLUETOOTH STANDBY".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
Some devices may take longer to respond. If you are
connected to a Bluetooth ® device before turning off the
system, wait for a minimum of 5 seconds before connecting
to this system from your Bluetooth
®
Software version
You can check the software version of the system.
1
Press [SETUP] to select "SW VER." and then press
[OK].
The software version is shown.
2
Press [OK] again to exit.
device again.