Clock And Timers - Panasonic SC-UX100 Owner's Manual

SC-UX100 PP TQBJ0973 En.fm Page 10 Saturday, August 13, 2016 5:06 PM
█
Selecting a preset station
1
Press [PLAY MENU] to select "TUNE MODE".
2
Press [R, T] to select "PRESET" and then press
[OK].
3
Press [2/3] or [5/6] to select the preset
station.
Using the main unit
1
Press [8] to select "PRESET".
2
Press [2/3] or [5/6] to select the preset
station.
Improving the sound quality
1
Press [PLAY MENU] to select "FM MODE".
2
Press [R, T] to select "MONO" and then press
[OK].
To cancel, select "STEREO".
"MONO" is also canceled when you change the
frequency.
To memorize the setting
Continue with step 4 of "Manual presetting".
Checking the signal status
Press [DISPLAY].
FM – – – – The FM signal is weak.
The system is not tuned in to a station.
FM ST The FM signal is in stereo.
FM MONO "MONO" is selected as the "FM MODE".
The FM signal is in monaural.
FM allocation setting
By main unit only
This system can also receive FM broadcasts allocated in
0.1 MHz steps.
1
Press [RADIO/AUX] to select "FM".
2
Press and hold [RADIO/AUX].
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, do the above steps
again.
• Preset frequencies are erased after you change the
setting.
10
Confidential
Until: 9 Jan 2017
digital printing

Clock and timers

Setting the clock
This is a 12-hour clock.
1
Press [SETUP] to select "CLOCK".
2
Press [R, T] to set the time and then press [OK].
To check the time
Press [SETUP] to select "CLOCK" and then press
[OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Sleep timer
The sleep timer turns off the system after the set time.
1
Press [SETUP] to select "SLEEP".
2
Press [R, T] to select the setting (in minutes) and
then press [OK].
To cancel, select "OFF".
Note:
•
The remaining time is shown for a few seconds every
minute. "SLEEP 1" is always shown when only 1 minute
remains.
•
The play timer and sleep timer can be used together.
• The sleep timer always comes first. Be sure not to set an
overlap of timers.
Play timer
(Except for Bluetooth ® and AUX source)
You can set the timer to come on at a certain time to
wake you up.
Preparation
Set the clock.
1
Press [SETUP] to select "TIMER ADJ".
2
Press [R, T] to set the start time and then press
[OK].
3
Do step 2 again to set the end time.
4
Press [R, T] to select the source you want to play
and then press [OK].