System Configuration And Configuration Devices; Devices Required To Construct A Network - Omron NY532-5400 User Manual

1-2 System Configuration and
Configuration Devices
1-2-1

Devices Required to Construct a Network

The basic configuration for an EtherNet/IP system includes one Ethernet switch to which nodes are
attached in star configuration using twisted-pair cable.
Sysmac Studio
(Support Software)
Ethernet (LAN) port
The following products are also required to build a network. Obtain them in advance.
(1) Per Node
NY-series (built-in EtherNet/IP port)
(NY52-)
NJ-series (built-in EtherNet/IP port)
(NJ501-, 301- or 101- )
NX-series (built-in EtherNet/IP port)
(NX701-)
OMRON PLCs
CJ2 (built-in EtherNet/IP port)
(CJ2H-CPU-EIP or CJ2M-CPU3)
CJ-series EtherNet/IP Unit*
(CJ1W-EIP21)
CS-series EtherNet/IP Unit
(CS1W-EIP21)
(2) Twisted-pair cable
(3) Ethernet switch
* The CJ1W-EIP21 can be mounted only to an NJ-series CPU Unit with unit version 1.01 or later and Sysmac Stu-
dio version 1.02 or higher.
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User's Manual (W563)
(3) Ethernet switch
(2) Twisted-pair cable
(1) Built-in EtherNet/IP
port on NY-series
100 m
Controller
max.
Network device
(1) Built-in EtherNet/IP
(1) Built-in EtherNet/IP
port on NJ/NX-se-
port on NJ/NX-se-
ries Controller
ries Controller
Function
These Units are used to connect to an EtherNet/IP net-
work.
The twisted-pair cable has a RJ45 Modular Connector
at each end. This cable is used to connect the built-in
EtherNet/IP port or EtherNet/IP Unit to an Ethernet
switch. Use an STP (shielded twisted-pair) cable of cat-
egory 5, 5e, or higher.
This is a relay device that connects multiple nodes in a
star LAN. For details on recommended devices to con-
figure a network, refer to 2-1-1 Recommended Network
Devices.
1 Introduction
1
1-5