Power Connection - Samsung SMARTCAM D1 User Manual

SmartCam d1 Installation
disassembling
Check whether or not the camera installation position is suitable for good video
`
J
reception.
Loosen the screws at the bottom of the
1.
product using the screwdriver as shown.
Pull apart the casing by pulling it apart.
2.

power connection

When installing SmartCam D1, connect the Power Adaptor to Chime bell.
When not connected, Some functions of SmartCam D1 and Chime Bell may not
work properly.
Only 16 to 24 volts AC power installed on the existing chime.
`
n
` Check and install a mechanical / electronic chime type.
Install and install the circuit breaker for safety reasons.
`
Refer to the Home page for a list of compatible chimes.
`
Connect the chime type to chime (default) when connecting the SmartCam D1 to the
`
J
16 AC adapter Transformer.
❖ Connection Structure
- Existing installation structures have been removed from the power stabilizer
in the picture below.
- Connect the two wires (black and white) to the two bunches of webbing, as
shown in the figure.
- Failure to connect may result in some functions of the SmartCam D1 and the
Chime Bell becoming inoperative.
Chime Bell
Power stabilizer
110V ; 20V
Transformer
11
02