Basic Maintenance - Fluke 1587 FC Calibration Manual

Basic Maintenance

This basic maintenance section of the manual contains tests and procedures that
require no equipment other than the Meter and some consumables such as fuses
and batteries. Also, internal access is limited to the battery and fuse
compartment.
h Static Awareness h
Semiconductors and integrated circuits can be damaged by electrostatic
X
discharge during handling. This notice explains how to minimize damage to
these components.
1. Understand the problem.
2. Learn the guidelines for proper handling.
3. Use the proper procedures, packaging, and bench techniques.
Follow these practices to minimize damage to static sensitive parts.
• Minimize handling.
• Handle static-sensitive
parts by non-conductive
edges.
• Do not slide static-
sensitive components
over any surface.
• When removing plug-in
assemblies, handle only
by non-conductive
edges.
• Never touch open-edge
connectors except at a
static-free work station.
To prevent electric shock or personal injury. De-
energize the product and all active circuits before
opening a product enclosure, touching or handling
any PCBs or components
• Keep parts in the original
containers until ready for
use.
• Use static shielding
containers for handling
and transport.
• Avoid plastic, vinyl, and
®
Styrofoam
area.
W Warning
.
• Handle static-sensitive
parts only at a static-
free work station.
• Put shorting strips on
the edge of the
connector to help
protect installed static-
sensitive parts.
in the work
• Use anti-static type
solder extraction tools
only.
• Use grounded-tip
soldering irons only.
Insulation Multimeters
Basic Maintenance
11