Table of Contents
Advertisement
VLAN Tag insertion
Active Mode
Active Mode
Active When
After finished the above settings, click OK to save the settings.
I
I
-
1
-
1
-
2
W
I
I
-
1
-
1
-
2
W
50
and uploading for such WAN interface. The unit is kbps.
Enable – Enable the function of VLAN with tag.
The router will add specific VLAN number to all packets on
the WAN while sending them out.
Please type the tag value and specify the priority for the
packets sending by WAN1.
Disable – Disable the function of VLAN with tag.
Tag value – Type the value as the VLAN ID number. The
range is form 0 to 4095.
Priority – Type the packet priority number for such VLAN.
The range is from 0 to 7.
Choose Always On to make the WAN1/WAN2/WAN3/WAN4
connection being activated always.
Load Balance: Check this box to enable auto load balance
function for such WAN interface.
When the data traffic is large, the WAN interface with the
function enabled will balance the data transmission
automatically among all of the WAN interfaces in
connection status.
Always On - Choose Always On to make the
WAN1/WAN2/WAN3/WAN4 connection being activated
always.
Load Balance: Check this box to enable auto load balance
function for such WAN interface.
When the data traffic is large, the WAN interface with the
function enabled will balance the data transmission
automatically among all of the WAN interfaces in
connection status.
Failover – Choose it to make the WAN connection as a
backup connection.
If you choose Failover as the Active Mode, the option of
Active When will appear.
A
N
5
(
U
S
B
)
A
N
5
(
U
S
B
)
WAN Failure – When the active WAN failed, such WAN
will be activated as the main network connection.
Traffic Threshold – When the data traffic of active
WAN reaches the traffic threshold (specified here),
the failover WAN will be enabled automatically to
share the overloaded data traffic.
Any of the selected WAN disconnect – Such WAN
connection will be activated when any selected WAN
interface (checked below) disconnects.
All of the selected WAN disconnect – Such WAN
connection will be activated only when all of selected
WAN interfaces (checked below) disconnect.
Check boxes for WAN1 to WAN5 – Specify the WAN
interface by checking the WAN box.
Vigor3220 Series User's Guide
Advertisement
Table of Contents
