Display Read-Out State; Display Mode - Danfoss FCM305 56 Instruction Manual

NOTE:
Using factory settings, the local control keys (bottom
4 of the display) will be active in Local Control or
Remote Control modes (parameter 002), except for
[FWD/REV] which is only active in Local operation.
All 4 local control keys can be disabled via
parameters 014-017.
NOTE:
Care should be taken when disabling the [STOP]
key! With no external stop function and parameter
014 disabled, the FCM 300 can be started, but
stopped only by disconnecting power to the motor.

Display Read-out State

The display read-out operating values can be
changed via parameters 009-012. A list of
selectable operating values follows:
Operating variable:
Reference
Reference
Feedback
Frequency
Frequency x scaling
Motor current
Torque
Power
Power
Motor voltage
DC-link voltage
FC thermal
Hours run
Input status, dig. Input
External reference
Status word
Heat sink temp.
Alarm word
Control word
Warning word 1
Warning word 2
Analog input 1
Analog input 2
*) Select in parameter 416.
The unit is shown in readout state 1 line 1 otherwise 'U'
is shown.

Display Mode

During normal operation, up to 4 different operating
variables can be viewed simultaneously on the
display. Each line of the display has a specific
purpose:
MG.03.B6.2G - VLT is a registered Danfoss trademark
FCM 300 Series
• • • • •
• • • • •
• • • • •
The number of variables to be viewed on the display is
determined by the read-out state:
Read-out
state:
Line 1
Unit:
[%]
[unit]*
Read-out state 1:
[unit]*
This read-out state is standard after start-up or
[Hz]
initializing the unit.
[-]
[A]
[%]
[kW]
[HP]
[V]
[V]
[%]
[Hours]
[Binary code]
[%]
[Hex]
[ºC]
[Hex]
Line 2 provides the operating variable and Line 1
[Hex]
gives a text description of Line 2. The displayed
[Hex]
[Hex] variable of Line 2 is programmable via parameter
[mA]
009. Or, the [+/-] keys scroll through the available
[V]
variable selections during normal operation.
Line 1 of the display lists 3 variables: 1.1, 1.2 and 1.3
Line 2 gives the fourth variable (shown as VAR 2)
Line 4 shows the present operating status or alarms
and warnings.
VAR 1.1 VAR 1.2 VAR 1.3
VAR 2
STATUS
I: II:
Description Data value
for operating for 3 operating for 3 operating
variable in line 2
variables in line 1
FREQUENCY
60.0 HZ
MOTOR IS RUNNING
III:
Description
variables in line 1
7-7