Local Operation Pad (Lop) - Danfoss FCM305 56 Instruction Manual

Remote Mounting Kit continued....

Local Operation Pad (LOP)

The LOP is wired directly to the X101 control
terminals. The LOP provides speed control, a start/
stop function and, depending on how it is wired and
programmed, the following three functions:
1. Dual speed operation
2. Dual mode operation (Uses 2-Set-up Menus)
3. Dual direction operation (For forward or reverse)
NOTE!
After wiring the LOP, cut off or isolate any
excess wire.
Function/settings Function/settings
Function/settings Function/settings Function/settings
Default - Dual speed operation Default - Dual speed operation Default - Dual speed operation Default - Dual speed operation Default - Dual speed operation
(connect orange wire): (connect orange wire): (connect orange wire): (connect orange wire): (connect orange wire):
No changes to factory setting.
Function 2 - Dual mode operation Function 2 - Dual mode operation Function 2 - Dual mode operation Function 2 - Dual mode operation Function 2 - Dual mode operation
(connect orange wire): (connect orange wire): (connect orange wire): (connect orange wire): (connect orange wire):
Select desired modes of operation
in Setups 1 and 2 (use para. 4-6)
Parameter 335 = 18 (select Setup)
Function 3 - Dual direction operation Function 3 - Dual direction operation Function 3 - Dual direction operation Function 3 - Dual direction operation Function 3 - Dual direction operation
(connect grey wire): (connect grey wire): (connect grey wire): (connect grey wire): (connect grey wire):
Parameter 335 = 10 (start reversing)
Parameter 200 = 1 (both directions)
*If no reset is required,
do not connect the brown wire
7-4
FCM 300 Series
At power up the unit will always be in stop mode.
Set reference will be stored during power down. If
permanent start mode is desired, connect terminal
6 to terminal 4 and do not connect orange/gray
wire to terminal 4. This means the stop function on
LOP is disabled.
W W W W W iring iring iring iring
iring
Color of wire Color of wire Color of wire Color of wire Color of wire
White
Brown
Orange or Gray
Green
Red
Yellow
Blue
Key Key (Start) (Start) Key Key (Start) (Start)
Key Key Key (Start) (Start) (Start) Key Key Key (Start) (Start) (Start)
Run on set Run on
reference 10 Hz**
(+/-) jog speed
Run with Run with
Setup 1 Setup 2
Run Run
forward reverse
**or set parameter 213
T T T T T erminal erminal erminal erminal erminal Function Function Function Function Function
2 Reference
3 Reset
4 See table under button
5 See table under button
6 +24V
7 +10V
8 Ground
Key Key (Stop) (Stop)
Key Key Key (Stop) (Stop) (Stop)
Stop (and
reset* - if trip)
Stop (and
reset* - if trip)
Stop (and
reset* - if trip)
MG.03.B6.2G - VLT is a registered Danfoss trademark
LCP-2