Assembling The Unit - Yamaha AvantGrand N3X Owner's Manual

When assembling the unit, consult a qualified AvantGrand dealer.
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct orientation. Please assemble in accordance with
the sequence given below.
• Assembly should be carried out by at least three persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can damage the instrument.
• Be sure to tighten all screws upon completing the assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver of the appropri-
ate size ready.
1
Remove the parts and collect them
together for assembly.
1-1 Remove the parts shown below from the
smaller box.
Legs
Front Rear Front
(L) (R)
Screws (4 pcs.)
Pedal brace rods (2 pcs.)
Cord holders (3 pcs.)

Assembling the Unit

Bolts (17 pcs.)
Pedal
Power cord
Wrench
(Used to tighten
bolts)
CAUTION
Do not lay the main unit upside down on the floor.
Incorrect
1-2 Set the larger box upright with the right side
up.
1-3 Cut the bands.
1-4 Remove the covers.
N3X
This side down
• 49
Owner's Manual