Connect The Pedal Cord; Connect The Power Cord - Yamaha AvantGrand N3X Owner's Manual

8

Connect the pedal cord.

8-1 Make sure the pedal cord is clipped into the cord
holder.
8-2 Insert the pedal cord plug into the pedal jack.
9

Connect the power cord.

9-1 Set the voltage selector and insert the power cord plug to the [AC IN] connector.
9-2 Attach the cord holders to the instrument, then clip the power cord into the holder.
Voltage Selector
Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To
set the selector for 110V, 127V, 220V or 240V main voltages, use a "minus" screwdriver to rotate the selector dial
so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at
240V when the unit is initially shipped. After the proper voltage has been selected, connect the AC power cord to
the AC IN and an AC wall outlet. A plug adaptor may be also provided in some areas to match the pin configura-
tion of the AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to the instrument or result in improper operation.
CAUTION
If the main unit creaks or is otherwise unsteady when you play on the keyboard, refer to the assembly diagrams and
retighten all screws.
After completing the assembly, please check the following.
Are there any parts left over?
 Review the assembly procedure and correct any errors.
Is the instrument clear of doors and other movable fixtures?
 Move the instrument to an appropriate location.
Does the instrument make a rattling noise when you shake it?
 Tighten all screws.
Is the power cord inserted securely into the sockets?
 Check the connection.
Is the pedal unstable?
 Loosen the screws of the pedal brace rods, then tighten the screws again while pushing the rods toward the pedal.
[AC IN] connector
(page 10)
Voltage
Selector
(the bottom of the left side as
seen from the front)
Assembling the Unit
N3X • 51
Owner's Manual