Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Rollei CARDVR-308
Summary of Contents for Rollei CARDVR-308
-
Page 2: Table Of Contents
Contents About this Guide ..............3 Recycling Information ............3 Conformity ................4 Battery Warning ..............4 Notes on Installation ............5 Caution ................6 Introduction ..............7 Features ..............7 Package Contents ............ 7 Product Overview ............. 8 Getting Started ............9 Storage Media ............ - Page 3 Automatic Record ..........18 3.1.1 The Recording Screen ......... 19 3.1.2 Emergency Recording ......... 21 Add Speed Point ............ 22 Picture in Video ............22 Parking Mode ............23 Collision Detection ..........25 Playback Videos and Photos ........26 3.6.1 Playback............
-
Page 4: About This Guide
Do not dispose old devices into the household waste! If the Rollei CarDVR-308 is no longer used, every consumer is legally obligated to dispose them separately from the household waste, for example, at a collection site of his community / city district. -
Page 5: Conformity
Conformity The Manufacturer hereby declares that the CE marking was applied to the Rollei CarDVR-308 in accordance with the basic requirements and other relevant provisions of the following CE Directives: 2011/65/EC RoHs Directive 2014/30/EU EMC Directive 2014/35/EU LVD Directive 2012/19/EC WEEE Directive... -
Page 6: Notes On Installation
Notes on Installation 1. Before installing the device, measure the front windshield viewing area, make sure not to block driver's front view, install the device below the rearview mirror (the central, higher right position of the front windshield). And we recommend that the sky and the land occupied by the screen 50%, fix the car holder and then adjust the device so that the lane is aligned with the screen. -
Page 7: Caution
Caution Due to local laws and vehicles safety considerations, do not operate this device while driving. Set up time zone, time and date accurately before you use this device. Please use SuperCar software under the condition that Electronic Map are functioning normally. The firmware function in the device is for reference only, drivers are advised to exercise discretion based on actual road conditions. -
Page 8: Introduction
Introduction Thank you for purchasing this advanced drive recorder. This product is specifically designed for real time video recording when driving. 1.1 Features SONY Sensor, low light enhancement • Full HD 1920*1080 • 3.0" TFT-LCD color screen • 155° Wide angle lens •... -
Page 9: Product Overview
1.3 Product Overview Item Item Menu / Back Button ( Wide Angle Lens Add Speed Point / Up Button Reset Hole Snapshot / Down Button ( Microphone Emergency Recording / Power Switch Confirm Button ( Voice Record Button ( Power Connector Port Memory Card Slot LED Indicator HDMI Connector Port... -
Page 10: Getting Started
Getting Started 2.1 Storage Media 2.1.1 Insert the Memory Card Insert memory card with the pins and the screen of the device facing forward, see the picture as below. Push the memory card in until a click sound is heard, indicating the card is in position. 2.1.2 Remove the Memory Card If the device is power on, please power off first and wait for the procedure of switching off the device completed before press the... -
Page 11: Installing In Vehicles
2.2 Installing in Vehicles 2.2.1 Mount to Windshield 2.2.2 Adjust the device position Knob... -
Page 12: Connecting To Power
2.3 Connecting to Power Use only the supplied car adapter to power up this device and charge the built-in battery. Connect one end of car adapter to power connector port on the device. USB port input: DC 5V / 1.0A. Plug the other end of the car adapter to the cigarette lighter socket of your vehicle. -
Page 13: Battery Status Indicator
2.3.1 Battery Status Indicator Icon Description Full battery power. 2/3 battery power. 1/3 battery power. Out of battery power. Battery is charging. Connect the car adapter to charge the battery, battery is fully charged. Note: 1. Use the products of the attached car adapter only, please do not use other brand car adapter, in order to avoid equipment burn or cause the battery explosion. -
Page 14: Led Indicator
2.4 LED Indicator Status Explanation LED Indicator Color Power off, battery charging Power off, battery full LED light off charged Power on, battery charging Power on, battery full Green charged Standby / Standby and Green screen off Recording/ Recording Flash red and screen off... -
Page 15: Powering The Device On / Off And Reset
2.5 Powering the Device On / Off and Reset 2.5.1 Auto Power On/Off If the device is connected to the vehicle power supply, once start the car engine, the device will automatically power on and start recording. Once the vehicle engine shuts down, the device automatically saves the recording and turns off the power within 10 seconds. -
Page 16: Initial Settings
2.6 Initial Settings Before using the device, we recommend you setup the correct Time zone, Date and Time. Note: Please note that if you press the button during recording, the system will stop recording and enter OSD menu. Make sure the recording is already stopped then continue operating the menu. - Page 17 Greenwich Mean Time (GMT) map of time zones: Note: 1. If Satellite Synchronization is on, device clock will be calibrated via satellite clock signal based on Set Time zone. Please refer to Satellite Synchronization ( 4.1). 2. If satellite positioning is not successful, device clock will run based on user defined time.
-
Page 18: Set The Date / Time
2.6.2 Set the Date / Time To set the correct date and time, do the following: Press the button to enter the OSD menu. Press the button to select Date / Time, and then press button entering function menu. Press the button to adjust the value, and then press button to set the next... -
Page 19: Using The Drive Recorder
Using the Drive Recorder 3.1 Automatic Record Once start the car engine, the device will automatically power on and start recording. Recording will automatically stop when the engine is switched off. Note: 1. Some vehicle power supply would not turn on / off automatically with the car engine start, if the device cannot automatically power on / off with the car engine, please manually connect the power supply with the vehicle power, and then power on, or manually power off the device and then release the... -
Page 20: The Recording Screen
3.1.1 The Recording Screen Icon Item Description Speed Current driving speed. Indicates the strength of satellite Satellite positioning. If the GPS:0 icon Positioning GPS:1 shows on screen, it indicates that the device cannot complete icon the satellite positioning. Recording Indicates the video current 00:10 Duration duration. - Page 21 Press to capture PIV (Picture in video screen shots from the front Video) Button camera. During video recording, press button to enter Emergency emergency recording mode. Recording Button Please refer to Emergency Recording (3.1.2). During video recording, press Voice Record button to switch Button the voice recording.
-
Page 22: Emergency Recording
3.1.2 Emergency Recording To Start the Emergency Recording, do the following: During Video Recording, press the button to enter emergency recording mode, the “Emergency” message will be shown immediately on the upper left corner of the screen, and the recorded file will be protected. The emergency video recording length is same as the recording interval setting. -
Page 23: Add Speed Point
3.2 Add Speed Point You may customize speed cam positions in this product. When the GPS positioning is completed , press update speed camera points. This product features a capacity of 200 speed cam positions. In case you are trying to add more than that the system prompts with message "Speed Position is full". -
Page 24: Parking Mode
3.4 Parking Mode To monitor the vehicle when it is parked, you can activate Vibration Detection, or Motion Detection. Follow the steps below to change the settings for Parking Mode: Press the button to enter the main menu. Press the button to select Parking Mode, and then press... - Page 25 engineer is started again, it will be back to normal loop recording. • Motion Detection: - If disconnected external power supply when the device is powered on, the system alert message “Press OK to power off or enter Parking mode after 10 sec”. This means system will...
-
Page 26: Collision Detection
3.5 Collision Detection If the Collision Detection function is enabled, this device begins emergency recording once it detects any collision. Sensitivity of the Collision Detection function is set to Normal by default, if user wants to change the settings of Collision Detection, do the following: Press the button to enter the OSD menu. -
Page 27: Playback Videos And Photos
3.6 Playback Videos and Photos 3.6.1 Playback Press the button to enter the OSD menu. Press the button to select then Playback, press button entering function menu. Press the button to select file types (Video / Event / Picture), and then press the button for entering menu. -
Page 28: Playback Mode
3.6.2 Playback Mode Video Playback Screen Picture Playback Screen Icon Item Description Indicates the type of the currently File Type playing file. Indicates the file name of video / File Name picture. Duration / Indicates the video elapsed time / Total 00:10 / 01:00 Indicates total recorded time. - Page 29 Icon Item Description When a compatible memory card is inserted, the LCD displays If no memory card is inserted or if TF Card the memory card is damaged / incompatible, the LCD displays Indicates battery power and Battery icon charging status. Shows the current file serial number Serial Number and total file number.
-
Page 30: Deleting Files
3.7 Deleting Files To delete file(s), perform the following steps: Press the button to enter the OSD menu. Press the button to select File Deletion, and then press button entering function menu. Press the button to select file types (Video / Event / Picture), and then press the button for entering menu. - Page 31 - Press the button to select item, and then press the button to confirm or cancel the selection. • Delete All: - Press the button to select Delete All, and then press button to delete all files in this file type. Press the repetitively to return recording screen.
-
Page 32: Adjusting The Settings
Adjusting the Settings 4.1 Menu Items Refer to the below table for details of main menu and function list. Menu option Description Available option Select the file category that Playback Video / Event / Picture you want to view. Displays the current state of Satellite Status the satellite reception. - Page 33 Menu option Description Available option Press the button to adjust the value, and Date / Time Set the date and time. then press the button to set the next field, and complete setting English Español/ Deutsch/ Italiano/ Language Language setting. Français/ Nederlands If the time stamp is enabled,...
- Page 34 Menu option Description Available option If one of parking mode is activated, the device will Off / Vibration Detection / Parking Mode enter parking mode 10 Motion Detection seconds after disconnect the external power. If Collision Detection is Off / High Sensitivity / Collision activated, this device starts Normal Sensitivity / Low...
-
Page 35: Connecting To Other Devices
Connecting to Other Devices 5.1 Connecting to the Computer You can connect the device to a desktop computer or notebook to transfer or view files. Connect mini USB cable to the power connector port of the device. Connect the other end of USB cable to an available USB port of your computer. -
Page 36: Connecting To Tv
5.2 Connecting to TV You can use HDMI cable transfer to TV to play the file. Power on the device. Connect HDMI cable to device HDMI port. Connect HDMI cable to TV HDMI port. Power on TV, switch TV signal input to HDMI, please operate by device buttons. -
Page 37: Installing The Software
Installing the Software Place the attached CD ROM into the CD player. If the CD does not execute automatically, please use Windows File Manager to execute the Install_CD.exe file in the CD. The following screen will be shown up. Press the [Menu] item to start the installation process according to the instructions on-screen. -
Page 38: Supercar
SuperCar Item Item Video Player File Path Play / Pause Browser File Previous File List Next File Name Stop Volume Current Duration / Total Google Map Duration Compass Signal Noise Ratio (SNR) Speed Meter G-Sensor Note: 1. To display the route on Electronic Map, please make sure the internet is connected before starting the video playback. -
Page 39: Specifications
Specifications Item Description Image sensor 1/2.9” SONY sensor 1920 (H) x 1080 (V) Effective pixels Supports Micro SDHC, up to 32GB class 10 speed or Storage media greater LCD display 3” LCD color TFT Wide Angle Fixed Focus lens Lens Aperture: Up to F1.8 Focus range 1.5m~Infinity... - Page 40 Item Description Built-in Li-polymer rechargeable (This battery is NOT Battery replaceable) Operating 0° ~ 60° C Temperature Operating 20 ~ 70% RH Humidity Storage -20° ~ 70° C Temperature Dimensions 87.6 x 53 x 28.5 mm Weight Approx. 86g (without memory card)
- Page 41 Copyright © 2017 All rights reserved. All other marks, products or company names mentioned in this guide are trademarks of their respective companies.