Cisco aironet 1810 series User Manual page 30

Network Diagnostics
Running Network Diagnostics via Controller CLI
From the wireless LAN controller CLI, you can use the following command to run network diagnostics:
show ap network-diagnostics ap-name
Example:
(Cisco Controller)> show ap network-diagnostics ap1
AP network diagnostics has been initiated
Waiting for network diagnostics to complete
======================= AP Network Diagnostics =====================
Speed Test Results:
DTLS Upload Speed
DTLS Download Speed
Non-DTLS Upload Speed
Non-DTLS Download Speed ................ 24.44 Mbps
Link Test Results:
Latency
Jitter
(Cisco Controller)>
Running Network Diagnostics via Controller GUI
You can initiate the network diagnostics tests from the Network Diagnostics tab in the controller GUI.
This tab is available at Wireless > All APs > Details.
Cisco Aironet 1810 Series OfficeExtend Access Point User Guide
2-16
................ 10.83 Mbps
................ 9.87 Mbps
................ 22.29 Mbps
................ 1 mSec
................ 0 mSec
Chapter 2 Understanding the Access Point GUI