Throttle Cable; Front Suspension; Rear Suspension; Driveshaft Bearing - Polaris FS Classic Owner's Manual

MAINTENANCE
Lubrication

Driveshaft Bearing

Inject grease into the fitting on the
speedometer sensor housing until grease
purges from the seal on the inside of the
tunnel. This should take approximately two
pumps. Do not use more than four pumps.

Throttle Cable

Lubricate the throttle cable lightly with
grease or oil. With the engine off, turn
the handlebars to the left and lubricate
liberally as shown.

Front Suspension

The front suspension and steering components do not require
lubrication.

Rear Suspension

Lubricate the suspension pivot shafts with Polaris Premium All Season
Grease at the intervals outlined in the Periodic Maintenance Table
beginning on page 88 and before seasonal storage. When operating in
heavy, wet snow conditions, lubricate every 500 miles (800 km).
Lack of lubrication will adversely affect your ride and the life of the
suspension. For more information about suspension lubrication and
adjustments, see your Polaris dealer.
M-10 128 Rear Suspension
L
L
L
L
98