NETGEAR PowerLEAP WiFi 1000 Quick Start Manual page 16

2. If you used a private encryption key, press the Security button on
one of the adapters already a part of the network for two seconds,
then press the Security button on the new adapter for two seconds.
Both buttons must be pressed within two minutes.
3. Secure the Powerline network:
a. On any of the adapters, press and hold the Security button
for two seconds.
b. On any one of the other adapters, press and hold the
Security button for two seconds.
Both buttons must be pressed within two minutes.
The Security button does not work in power saving mode
Note:
Do not press the Security button on the Powerline adapter until
installation is complete and the adapters are communicating with each
other (indicated by the blinking Power LED). Pressing this button too
soon can temporarily disable Powerline communication. If this occurs, use
the Factory Reset button to return the Powerline adapter to its factory
default settings.
4. Wait for the Powerline network to recognize each Powerline device.
This process could take as little as 5 seconds or up to 80 seconds.
16