Notice For This Monitor - Eizo DuraVision User Manual

Notice for This Monitor

This product may not be covered by warranty for uses other than those described in the Setup Manual.
The specifications noted in this manual are only applicable when using power cords and signal cables
specified by us.
Only use optional products manufactured or specified by us with this product.
It takes about 30 minutes for the performance of electrical parts to stabilize. Please wait 30 minutes or more
after the monitor power has been turned on, and then adjust the monitor.
Monitors should be used with "Backlight" set to relatively low brightness to minimize degradation of
luminosity caused by long-term use, and to maintain a stable display.
When the screen image is changed after displaying the same image for extended periods of time, an
afterimage may appear. Use the screen saver or power save function to avoid displaying the same image for
extended periods of time. Depending on the image, an afterimage may appear even if it was displayed for
a short period of time. To remove such a phenomenon, change the image or keep the power turned off for
several hours.
If the monitor displays continuously over a long period of time, dark smudges or burn-in may appear. To
maximize the life of the monitor, we recommend the monitor be turned off periodically.
Do not splash detergent or hot water on the surface of the LCD panel, or bring any open flames close to it.
Doing so may cause the coating on the monitor surface to peel off and leave distinguishing traces.
Periodic cleaning is recommended to keep the monitor looking new and to prolong its operation lifetime (refer
to "Cleaning" (page 4)).
The LCD panel is manufactured using high-precision technology. Although, missing pixels or lit pixels may
appear on the LCD panel, this is not a malfunction. Percentage of effective dots: 99.9994 % or higher.
The backlight of the LCD panel has a fixed lifetime. Depending on the usage pattern, such as usage for
long continuous periods, the lifespan of the backlight may run out sooner, requiring replacement. When the
screen becomes dark or begins to flicker, please contact your local EIZO representative.
Do not scratch or press on the surface of the LCD panel with any sharp objects, as this may result in surface
damage. Rubbing the surface using tissues may also scratch the surface.
When the monitor is cold and brought into a room or the room temperature goes up quickly, dew
condensation may occur on the interior and exterior surfaces of the monitor. In that case, do not turn the
monitor on. Instead wait until the dew condensation disappears, otherwise it may cause some damage to the
monitor.
(Cautions for the Use of the Touch Panel)
Be sure to note the following points. Otherwise, damage or a malfunction may result.
• Do not place any objects on the touch panel.
• Do not apply excessive pressure to, scratch, or poke the touch panel.
• Do not touch the touch panel with hard objects such as ball point pens or metals.
3
Notice for This Monitor