Chapter 4 Maintenance; How To Replace The Dc Power Fuse - Eizo DuraVision User Manual

Chapter 4 Maintenance

4-1. How to Replace the DC Power Fuse

Attention
• Be sure to follow the procedure when replacing the fuse. Note that EIZO Corporation assumes no responsibility
for any damage caused due to incorrect handling of this product.
• Always use the following fuse.
- Manufacturer: Littelfuse
- Mode No.: 0217010.MXP
- Rating: 250 V / 10 A
- Shape: Tube type
- Size: 5 mm x 20 mm
- Type: Fast-blow
1.
Disconnect the AC power cord and DC power terminal block.
2.
Remove the fuse holder.
Hold down the tip of the fuse holder using a flat-head screwdriver, and rotate it counterclockwise.
3.
Attach a new fuse to the fuse holder.
4.
Install the fuse holder.
Insert the fuse holder into the monitor. Hold down the tip of the fuse holder using a flat-head
screwdriver, and rotate it clockwise.
DC power fuse holder
Note
• After replacement, connect the DC power terminal block with the AC power cord disconnected, and check that
the monitor works normally
1. Loosen
Flat-head screwdriver
Fuse
2. Attach
3. Tighten
Fuse holder
Chapter 4 Maintenance
21