Safety Guards - Vision Fitness X6100 Assembly Manual

6
STEP
Link Arm
Covers
O P T I O N A L

SAFETY GUARDS

• NOTE: Elliptical Trainer cannot be
folded with the child safety guards in
place.
• Line up the grooves on the child
safety guards with the screws on the
guide rails. Slide the safety guard into
place on the guide rails. Tighten the
screws with the screwdriver
lock in place.
Dual-Action
Axle Cover
OPTIONAL
STEP
5
STEP
to
6
9
BLACK BAG
• On the right side, slide the dual-
action axle cover into place on the con-
sole mast axle. Slide a wavy washer
(25x34x2T) onto the axle. Slide the
right dual-action arm on the axle. Fix in
place with the washer (8x35x2T) and
locknut (M8). Cover with the included
nut cap.
• Make sure the sleeve is in place in
the socket joint of the lower link arm.
Connect the lower link arm to the dual
action arm with a screw (M8x30L).
Attach the washer (8x16.1.5T) and nut
(M8) to the end of the screw. Tighten
with the 6mm L-Shaped wrench and
13mm wrench.
• Position the link arm cover over the
joint of the lower link arm and secure
the two pieces of the cover together
with a panhead screw (M4x15L).
Connect the cover to each side of the
lower link arm with a washer
(5x10x1T) and screw (M5x10L).
• Repeat these steps on the left side.
5
STEP
Dual-Action
Arm