Safety Guards - Vision Fitness X6200HRT Assembly Manual

5
STEP
OPTIONAL
6
STEP
O P T I O N A L

SAFETY GUARDS

6
STEP
• NOTE: Elliptical Trainer cannot be
folded with the child safety guards in
place.
• Line up the grooves on the child
safety guards with the screws on the
guide rails. Slide the safety guard into
place on the guide rails. Tighten the
screws with the Phillips screwdriver to
lock in place.
5
STEP
500 South CP Avenue • P.O. Box 280 • Lake Mills. WI 53551
toll free 1.800.335.4348 • phone 1.920.648.4090 • fax 1.920.648.3373
www.visionfitness.com
2002 Vision Fitness. All Rights Reserved. 9.02 Part #Z62EP34-AG1823PRD
AG18.23PRD
REV1
8
BLACK BAG
• On the right side, slide the dual
action axle cover into place on the
axle located on the console mast.
Slide the right dual action arm into
place on the axle. Fix in place with
the washer (M8x35x2t) and locknut
(M8). Cover with the included nut
cap.
• Make sure the bushing is in place in
the socket joint of the lower link arm.
Connect the lower link arm to the
dual-action arm with
(M8x55L), washer (M8x16x1.5T),
and nut (M8). Tighten with the 6
Allen wrench and 17 wrench.
MM
• Position the link arm cover into
place over the joint of the lower link
arm and the dual action arm. Secure
the two pieces of the cover together
by inserting and tightening a screw
(M5x10L) in the front of the cover.
Connect the cover to each side of the
lower link arm with a washer (M5)
and screw (M4x10L).
• Repeat these steps on the left side.
a screw
MM