Edimax AR-7288WnA Manual page 43

Step 6 In this page, you can enter the PPP username and PPP password
provided by your ISP. Select the authentication method according to
your requirement. After setting, click Next to display the following page.
 PPP Username/PPP Password: The correct user name provided by your
ISP.
 Authentication Method: The value can be AUTO, PAP, CHAP, or MSCHAP.
Usually, you can select AUTO.
 Enable Fullcone NAT:. NAT is one where all requests from the same
internal IP address and port are mapped to the same external IP address
and port. Furthermore, any external host can send a packet to the
internal host, by sending a packet to the mapped external address.
 Dial on demand (with idle timeout timer): If this function is enabled, you
need to enter the idle timeout time. Within the preset minutes, if the
modem does not detect the flow of the user continuously, the modem
automatically stops the PPPoA connection. Once it detects the flow (like
access to a webpage), the modem restarts the PPPoA dialup. If this
function is disabled, the modem performs PPPoA dial-up all the time. The
PPPoA connnection does not stop, unless the modem is powered off and
DSLAM or uplink equipment is abnormal.
 Enable IPv4 for this service: Check this checkbox, this interface will
support IPv4.
 Use Static IPv4 Address: If this function is disabled, the modem obtains
an IP address assigned by an uplink equipment such as BAS, through
PPPoA dial-up. If this function is enabled, the modem uses this IP address
as the WAN IP address.
 Enable IPv6 for this service: Check this checkbox, this interface will
support IPv4.
 Enable PPP Debug Mode:Enable or disable this function.
 Enable IGMP Multicast Proxy: If you want PPPoE mode to support IPTV,
enable it.
43