Specific Service Instructions; Disassembly - JVC KW-NX7000J Service Manual

This service manual does not describe SPECIFIC SERVICE INSTRUCTIONS.
3.1 Main body
3.1.1 Removing the Heat sink (See Fig.1)
(1) Remove the three screws A and four screws B attaching
the Heat sink.
3.1.2 Removing the Rear bracket (See Fig.2 to 4)
(1) Remove the three screws C attaching the Rear heat
sink.(See Fig.2)
(2) Remove the ten screws D and one screw E attaching the
rear bracket. (See Fig.3)
(3) Disconnect the connector wire from Car cable connected to
connector CN601 of the Sub board. (See Fig.4)
(4) Disconnect the connector wire from Fan connected to con-
nector CN604 of the Sub board. (See Fig.4)
(5) Disconnect the card wire from Main board connected to
connector CN605 of the Sub board. (See Fig.4)
(6) Disconnect the connector wire from Main board connected
to connector CN607 of the Sub board. (See Fig.4)
C
SECTION 2

SPECIFIC SERVICE INSTRUCTIONS

SECTION 3

DISASSEMBLY

Fig.2
B
A
Fig.1
E
D
D
Fig.3
CN605 CN607 CN601
Fig.4
B
D
CN604
(No.MA427<Rev.001>)1-9