Table of Contents
Advertisement
2.2.1 Ports Speed
n 100Base-TX
All 100Base-TX ports come with auto-negotiation capability.
They automatically support 100Base-TX and 10Base-T
networks. Users only need to plug a working network device
into one of the 100Base-TX ports, then turn on the switch.
The port will automatically runs in 10Mbps, 20Mbps,
100Mbps or 200Mbps after the negotiation with the con-
nected device.
2.2.2 Cabling
100Base-TX ports use RJ-45 sockets -- similar to phone
jacks -- for connection of unshielded twisted-pair cable (UTP).
The IEEE 802.3u Fast Ethernet standard requires Category 5
UTP for 100Mbps 100Base-TX. 10Base-T networks can use
Cat.3, 4, or 5 UTP (see table A)
Port Type
Cable Type
10Base-T
Cat 3, 4, 5
100Base-TX
Cat.5/5e UTP
Table A: Supported port list
2.2.3 Auto-MDI/MDI-X
Each numbered port of FNSW-3200 is MDI/MDI-X port.
Which automatically detects straight-through/ crossover ca-
ble types. You can direct use straight cable for the connection
to your workstation or other end nodes. Either straight or
cross-over cable can be used to connect switch, hub or end
nodes without any hassle.
Connector
RJ-45
RJ-45
- 4 -
Advertisement
Table of Contents
