Page 1: Table Of Contents
We recommend that you take a few minutes to read carefully through this manual before installing and switching on the monitor. Please keep this manual in a safe place for your future reference. Plug & Play Drivers for the AOC Spectrum Series Monitors are available at AOC’ s Web Site: www.AOCmonitor.com...
Page 2: For Your Safety
Before operating the monitor please read this manual thoroughly. This manual should be retained for future reference. FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS) NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Page 3: Safety Precautions
PRECAUTIONS l Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. l Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and cause serious damage to the appliance.
Page 4: Special Notes On Lcd Monitors
• ® EPA E NERGY • Ergonomic Design (MPRII Approved) • Space Saving, Compact Case Design CHECKING THE CONTENTS OF THE LM-510 PACKAGE The product package should include the following items: LCD Monitor Owner's Manual Power Cord External Adapter Driver-Disk...
Page 5: Installation Instructions
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS SWIVEL BASE Install Remove Figure 1 Installing and Removing the Swivel Base POWERCORD Power Source: 1. Make sure the power cord is the correct type that required in your area. 2. This LCD monitor has a universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required.) 3.
Page 6: Controls And Connectors
CONTROLS AND CONNECTORS VIDEO CABLE Connecting the Video Cable: the LCD monitor comes with a built-in video cable. Plug the signal cable′s 15-pin connector into the computer's video port and tighten the two screws on the cable connector. Connecting the Power Cord: Plug the power cord into the LCD monitor's AC power socket.
Page 7: Adjusting The Viewing Angle
ADJUSTING THE VIEWING ANGLE INSTALLATION INSTRUCTIONS • For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’ s angle to your own preference. • Hold the stand so you do not topple the monitor when you change the monitor’...
Page 8: Operating Instructions
OPERATING INSTRUCTIONS GENERAL INSTRUCTIONS Press the power button to turn the monitor on or off. The other control knobs are located at front panel of the monitor (See Figure 4). By changing these settings, the picture can be adjusted to your personal preferences. •...
Page 9 FRONT PANEL CONTROL • Power Press this knob to switch ON/OFF of monitor’ s power. • MENU/Exit : Active OSD menu or function adjust confirm or Exit OSD menu when in Brightness/Contrast OSD status. • Contrast Adjust contrast or function adjust. •...
Page 10: How To Adjust A Setting
HOW TO ADJUST A SETTING 1. Press the MENU-Key to make the OSD window appear. See figure 5. 2. Press to select the desired function. See figure 5. 3. Press the MENU-Key to select the function that you want to adjust. 4.
Page 11: How To Optimize The Dos-Mode
Adjusts Red intensity. Green Adjusts Green intensity. Blue Adjusts Blue intensity. The color temperature for 7300°K is (7300K) Color x=0.301, y=0.317. The color temperature for 9300°K is (9300K) Color x=0.281, y=0.311. Clear each old status of auto-configuration Reset And re-do auto-configuration. Exit Save user adjustment and OSD disappear.
Page 12: Plug And Play
PLUG AND PLAY Plug & Play DDC1/2B Feature This monitor is equipped with VESA DDC1/2B capabilities according to the VESA DDC STANDARD. It allows the monitor to inform the host system of its identity and, depending on the level of DDC used, communicate additional information about its display capabilities.
Page 13: Technical Support(Faq)
*Check if the Video Card is Plug & Play compatible *Check if the D-15 plug pin of Video Cable is bent *Make sure the AOC Monitor Drivers are installed (AOC Monitor Drivers are available at: www.AOCmonitor.com) Picture is fuzzy *Adjust the Contrast and Brightness Controls.
Page 14 Screen image is not centered or sized *Adjust pixel frequency (CLOCK) and properly. FOCUS or press hot-key (AUTO) Picture has color defects *Adjust RGB color or select color (white does not look white) temperature Poor brightness or contrast *The life time of the back-light is limited.In 10000 Hours the luminance of the light has been reduced to half of its original value.
Page 15: Error Message & Possible Solution
ERROR MESSAGE & POSSIBLE SOLUTION CABLE NOT CONNECTED : Check that the signal-cable is properly connected , If the connector is loose, tighten the connector’ s screws. Check the signal-cable’ s connection pins for damage. INPUT NOT SUPPORT : Your computer has been set to unsuitable display mode ,Set the computer to display mode given in the following table.
Page 16: How To Install Inf & Icm File
Click “START” , select “SETTINGS”, select “CONTROL PANEL “Select “SYSTEM”, select “DEVICE MANAGEMENT“, select “MONITOR” icon and click twice ,you can see the Description as follow : “AOC LCD MONITOR LM-510 “ if this description doesn’ t exist, or the “MONITOR” icon no exist too,that means your installation not success.
Page 17: Appendix
APPENDIX SPECIFICATIONS Driving system TFT Color LCD LCD Panel Size 38.1cm(15.0") Pixel pitch 0.297mm( H )x 0.297mm( V ) Viewable angle 120° (H) 85° (V) Response time 50 ms Video R,G,B Analog Interface Input Separate Sync. H/V TTL H-Frequency 30kHz – 60kHz V-Frequency 55-75Hz Display Colors...
Page 18 • Switch Auto Adjust Key • / Brightness • / Contrast • Power Switch • MENU/ Exit • External Controls: Functions Contrast • Brightness • Focus • Clock • H-Position • V-Position • Language • 7300°K • 9300°K • RGB Color temperature •...
Page 19: Factory Preset Timing Table
FACTORY PRESET TIMING TABLE HORIZONTAL VERTICAL STANDARD RESOLUTION FREQUENCY FREQUENCY 720 × 400 31.47kHz 70Hz 640 × 480 31.47kHz 60Hz 640 × 480 35.00kHz 66.6Hz 640 × 480 37.50kHz 75Hz 800 × 600 37.879kHz 60Hz SVGA 800 × 600 46.875kHz 75Hz 832 ×...
Page 20: Limited Three-Year Warranty
WARRANTY STATEMENT for AOC Color Monitors Including those Sold within North America as Specified Envision Peripherals, Inc. warrants this product to be free from defects in material and workmanship for a period of three (3) years after the original date of consumer purchase. During this period, EPI (EPI is the abbreviation for Envision Peripherals, Inc.) will, at its option, either repair the defective...
Page 21 l Improper environment l Excessive or inadequate heating or air conditioning or electrical power failures, surges, or other irregularities This three-year limited warranty does not cover any of the product's firmware or hardware that you or any third party have modified or altered; you bear the sole responsibility and liability for any such modification or alteration.
Page 22 • AOC repaired monitor *AOC will need to obtain a credit card number if you would like to get a new AOC monitor advanced shipped to your location, prior to the defective unit arriving at AOC’s service center. If you do not wish to supply a credit card, AOC will only ship the new monitor, once the defective unit arrives at the AOC service center.
Page 23 P/N : 41A401-969...

AOC LM-510 User Manual

Quick Links

TABLE OF CONTENTS

Related Manuals for AOC LM-510

Summary of Contents for AOC LM-510

Table of Contents