Service Aids And Recommended Tools; Field Programming - Motorola MCS 2000 Service Instructions Manual

Service Aids
and
Recommended
Tools
Field
Programming
Part Number
RKN4062B Programming and Cloning Cable
RKN4063A FLASH, Programming and
Cloning Cable with Test Box
3080376E36 Control Head Extender Cable
*
GTF373A Test Box Cable
GTF372A* Combined Interface Cable
HKN4191A DC Power Cable for radios
HKN6110 DC Power Cable for radios
RLN4460A or Test Box
GTF180B*
RLN4008B Radio Interface Box
0180358A56 or Power Supply
EPN4041A*
0180357A57 Power Supply
EPN4040A* Power Supply
3080369B71 or Computer Interface Cable
3080369B72
RLN4438A Adapter
RLN1015B Smart Radio Interface Box (SRIB)
0180302E27 SRIB Power Supply
2580373E86 SRIB Power Supply
RLN4488A SRIB Battery Pack
3080390B48 or Computer Interface Cable
3080390B49
2705438Y01 Chassis Eliminator
2705816W03 Chassis Eliminator
2705815W03 Chassis Eliminator
3-2 Test Equipment, Service Aids, and Tools
Refer to the "SERVICE AIDS" and "RECOMMENDED TOOLS LIST" for a listing
and description of the service aids and tools designed specifically for servicing
the radio, as well as the more common tools required to disassemble and
properly maintain the radio. These kits and/or parts are available from
Motorola.
The following table lists service aids recommended for working on the radio.
While all of these items are available from Motorola, most are standard shop
equipment items, and any equivalent item capable of the same performance
may be substituted for the item listed.
The radio can be aligned and programmed in the field. This requires specific
equipment and special instructions. Refer to the "Radio Service Software User's
Manual" for complete field programming information.
Table 3-2 Service Aids
Description
Connects the RIB RLN4008B to the microphone connector. Cloning is the
act of transferring programmed data from one radio to another.
Connects the RIB RLN4008B to the accessory connector. Cloning is the act
of transferring programmed data from one radio to another. FLASHing is the
act of adding new software to the radio.
Connects the control head to the 18 pin connector.
(see page 4 for correct use of this cable).
Connects radio to GTF180B test box.
Connects radio to RLN4008B RIB and Microphone Port and Accessory
Connector.
Interconnects radio below 50 W to power supply.
Interconnects radio of over 50 W to power supply.
Allows switching for radio testing.
Enables communications between the radio and the computer's serial
communications adapter.
Used to supply power to the RIB (220 VAC).
Used to supply power to the RIB (110 VAC).
Used to supply power to the RIB (240 VAC).
Use B72 for the IBM PC AT. All other IBM models use B71. Connects the
computer's serial communications adapter to the RIB.
25 pin (F) to 9 pin (M) adapter, for use with 3080369B72 for AT applications.
Enables communications between the radio and the computer's serial
communications adapter. For FLASHing, programming and cloning.
Used to supply power to the SRIB (120 VAC).
Used to supply power to the SRIB (220 VAC).
Used to power the SRIB from a battery.
Use B49 for the IBM PC AT. All other IBM models use B48. Connects the
computer's serial communications adapter to the SRIB only.
For Low Power radios.
For Mid Power radios.
For High Power radios.
Application