Security - Planet WAP-4000A User Manual

PLANET WAP-4000A
interoperability if you want to set the AP in the above-mentioned modes to associate with
other brands of APs or routers.
11g Only Mode: Enabling 11g only mode maximizes the performance of WAP-4000A in a
pure 802.11g WLAN, but 802.11b clients are not allowed to connect to it. Disabling this
option allows both 802.11g and 802.11b clients to connect to WAP-4000A.
Super G Mode: There are four options selectable: Disabled, Super G without Turbo,
Super G with Dynamic Turbo, and Super G with Static Turbo. When you use Super G
mode, it is recommended to enable 11g only for best performance.
Antenna Transmit Power: You can control the transmit power of WAP-4000A here. There
are five options available: full, half (-3dB), quarter (-6dB), eighth (-9dB), and min.
Aging Interval: To limited STA connect timing

3.7 Security

You can change Administrator ID, Password and set the MAC Filter settings in this
option.
Password: Enter the new password in the AP Password New field and again in the next
field to confirm. Click on Apply to execute the password change. The Password is
case-sensitive, and can be made up of any keyboard characters. The new password must
be between 0 and 15 characters in length.
MAC Filters: Filter function is for the administrator to authorize who can gain network
Figure14
- 15 -
User Manual