Jabra GO 6470 Quick Start Manual page 10

page 2-3.pdf 15-11-2007 13:11:02
The Jabra brand is wholly owned by GN US, Inc. Customer service is provided by GN US, Inc. Please see details below.
General safety guidelines
• Follow the instructions to ensure correct and safe installation and
interconnection of the apparatus.
• Be sure to disconnect telephone line before connection, installation,
removal or servicing.
Incorrect connection may cause injure.
USA Declaration
USA FCC part 15
For wireless products and telephones
FCC Notice to Users/Product Statements
This device complies with part 15 of the FCC rules. Operation is subject
English 3
to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may
Français 9
cause undesired operation.
Users are not permitted to make changes or modify the device in any way.
WARNING: Changes or modifications not expressly approved by
Español 15
GN Netcom Inc. will void the user's authority to operate the equipment.
Applies to wireless products only
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Applies for wireless products with base station only
The user must place the base at least 8" (20cm) or more from any per-
sonnel and must not be co-loaded or operating in conjunction with any
other antenna or transmitter in order to comply with FCC RF exposure
requirements.
RF Exposure Headset (US DECT):
Tests for SAR are conducted using standard operating positions specified
by the FCC with the UPCS headset transmitting at its highest certified
power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the
actual SAR level of the UPCS headset while operation can be well below
the maximum value. This is because the headset is designed to operate
at multiple power levels so as to use only the power required to reach
the network. In general, the closer you are to a wireless base station
antenna, the lower the power output.
Before a Headset model is available for sale to the public, it must be
tested and certified to the FCC that it does not exceed the limit estab-
lished by the government-adopted requirement for safe exposure.
The tests are performed in positions and locations (e.g., at the ear) as
required by the FCC for each model.
While there may be differences between the SAR levels of various UPCS
headsets and at various positions, they all meet the government
requirement for safe exposure.
Health and Safety Information FCC:
Exposure to Radio Frequency (RF) Signals
Your wireless headset is a radio transmitter and receiver. It is designed
and manufactured not to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal Communications Com-
3