Pre-Start Checklist; Maintenance; Air Filter - Rheem RHSL-HM1817AA Installation Instructions Manual

Rhll high efficiency rhsl standard efficiency
Table of Contents

Advertisement

36

11.0 PRE-START CHECKLIST

PRE-START CHECKLIST
H
Is unit properly located, level, secure and service-
YES
H
NO
able?
Has auxiliary pan been provided under the unit with
H
YES
separate drain? (Units installed above a finished
H
NO
ceiling).
Is condensate line properly sized, run, trapped,
H
YES
pitched and tested?
H
NO
Is ductwork correctly sized, run, taped and insulat-
H
YES
H
ed?
NO
Have all cabinet openings and wiring been sealed
H
YES
H
NO
with caulking?
H
YES
Is the filter clean, in place and of adequate size?
H
NO
H
YES
Is the wiring tight, correct and to the wiring diagram?
H
NO
H
YES
Is the unit properly grounded and protected (fused)?
H
NO
H
YES
Is the thermostat heat anticipator been set properly?
H
NO
H
YES
Is the unit circuit breaker(s) rotated properly "on" up
H
NO
- "off" down?
Are the unit circuit breaker(s) line lug cover(s) in
H
YES
H
place?
NO
H
YES
Are all access panels in place and secure?
H
NO
Refer to outdoor unit installation instructions for system
start-up instructions and refrigerant charging instructions.

12.0 MAINTENANCE

For continuing high performance, and to minimize possible equipment failure, it is essen-
tial that periodic maintenance be performed on this equipment. Consult your local dealer
as to the proper frequency of maintenance and the availability of a maintenance contract
IMPORTANT: Before performing any service or maintenance procedures, see the
"Safety Information" section at the front of this manual.
WARNING
Units with circuit breaker(s) meet requirements as a service disconnect switch,
however, if access is required to the line side (covered) of the circuit breaker,
this side of the breaker(s) will be energized with the breaker(s) de-energized.
Contact with the line side can cause electrical shock resulting in personal
injury or death.
12.1 AIR FILTER (NOT FACTORY-INSTALLED)
Check the system filter every ninety days or as often as found to be necessary and if
obstructed, clean or replace at once.
FILTER MAINTENANCE
Have your qualified installer, service agency or HVAC professional instruct you on how
to access your filters for regular maintenance.
IMPORTANT: Do not operate the system without a filter in place.
• New filters are available from your local distributor.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents